Celcius CTW forum

forum for everything CTW


You are not connected. Please login or register

Problem? i really dont know

View previous topic View next topic Go down  Message [Page 1 of 1]

1 Problem? i really dont know on Sun Apr 22, 2012 10:07 am

thekiller


Private
Private
Hi.
Did you know what is that sound??


i really dont know waht is...some help.

View user profile

2 Re: Problem? i really dont know on Sun Apr 22, 2012 1:34 pm

The braking MOSFET seems gone away.
You need to replace rear board or to replace two MOSFETs on it. It's not hard, just solder them out and in.

View user profile

3 Re: Problem? i really dont know on Tue Apr 24, 2012 5:59 am

twingear

avatar
Private
Private
With CLU-300 and CLU-350 use 11.1v 1200mAh.

View user profile

4 Re: Problem? i really dont know on Tue Apr 24, 2012 4:39 pm

deadlyzach

avatar
Corporal
Corporal
I wouldn't be so sure that this problem is the mosfet, in my case it was a weak motor that eventually just stopped working completely, i replaced the motor with an fcc gen 2 and this problem was gone.

View user profile

5 Re: Problem? i really dont know on Wed Apr 25, 2012 6:00 am

Joe90

avatar
Sargeant
Sargeant
In the case of aegs with a weak motor and an ascu this problem happens, if the ab was gone i figure the over run would be a little more than whats shown in the vid, maybe not but i too suggest the motor may be weakening as it were.

View user profile

Sponsored content


View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum